[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] Model a Chiller:Electric or Chiller:Electric:EIR





That looks good, I don't understand the color coding, but looking past that the user should be able to figure it out.

On the Info sheet. I would suggest more explanations. Copy this into your spreadsheet. Then upload it.

This is a spreadsheet used for calculating the CAPFT, EIRFT and EIRFPLR performance curves which are needed to model a chiller in EnergyPlus. For example, the "Chiller:Electric:EIR", or Chiller:Eelctric:ReformulatedEIR" models.

The data that we need from the manufacturer depends on the chiller model selected for simulation. The Chiller:Electric:EIR model uses leaving evaporator water temperature and entering condenser air or water temperature. The Chiller:Electric:ReformulatedEIR model uses leaving evaporator water temperature and leaving condenser air or water temperature  To create the CAPFT performance curve,  cooling capacity at several different conditions of supply chilled water temperature (outlet or leaving evaporator water temperature) and the condenser inlet or outlet water or air temperature is needed. The more data available, the better the performance curve. The data needed for the EIRFT curve is cooling capacity and power for different operating conditions (same conditions as CAPFT).

The data that we need from the manufacturer for the EIRFPLR curve are the cooling capacity and power for different Part Load Ratios or Loading Ratios (%).

These curves must be normalized to 1 at the rating point. This means that capacity data needs to be divided by the rated capacity. for EIR, the power divided by capacity is used, and also normalized by dividing by the rated EIR.

On the CAPFT, EIRFT, and EIRFPLR sheets, I would change Unit Rate to Power. You could also add units to make things very clear (e.g., Power (W), Capacity (W), etc.

Good job.

On 12/1/2011 10:44 AM, Nacho Gomis wrote:
 

Hi again Richard and other reader,if there are.
I have the spreadsheet, I think is ready for uploading it to the files area.

If you can check it,I will be grateful.

Thanks,
Ignacio Gomis


-- 
Richard A. Raustad
Senior Research Engineer
Florida Solar Energy Center
University of Central Florida
1679 Clearlake Road
Cocoa, FL  32922-5703
Phone:   (321) 638-1454
Fax:     (321) 638-1439 or 1010
Visit our web site at: http://www.fsec.ucf.edu

UCF - From Promise to Prominence: Celebrating 40 Years


__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___