[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [EnergyPlus_Support] time setpoint not met during cooling hours





Try with the sizing factors. Or modify your cooling  setpoint.


To: EnergyPlus_Support@xxxxxxxxxxxxxxx
From: iluminasol33@xxxxxxxxx
Date: Fri, 6 Jan 2012 17:48:10 +0000
Subject: [EnergyPlus_Support] time setpoint not met during cooling hours

 
Dear Forum,

I am modeling a 4 floor building and I am using a single duct parallel PIU reheat terminals and a central two speed DC cooling. The model works properly, except that the amount of hours that the setpoint is not met for cooling during occupied hours is quite big (cooling setpoint: 24 C). First I put the design flow rate and cooling capacity in autosize option and then tried to configure it manually but for both cases its the same amount of hours outside the cooling setpoint.

Any advice would be greatly appreciated.

Thanks,
Santiago




__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___