Re: [EnergyPlus_Support] Discrepancy in reporting

On Thu, Sep 27, 2012 at 11:57 AM, Griffith, Brent <brent.griffith@xxxxxxxx> wrote:

The child, DX heat pump heating coil has its own reports, such as ?DX Heating Coil Electric Consumption? ,
?DX Heating Coil Electric Defrost Consumption? and ?DX Heating Coil Crankcase Heater Consumption?

The MTD output file contains lists of what reports are on the various meters, including meters used for end use summary.

From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On Behalf Of Vinay Devanathan
Sent: Thursday, September 27, 2012 9:40 AM

To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: Re: [EnergyPlus_Support] Discrepancy in reporting

Thanks, Brent. I got your reply for my ticket too.

Do you think I can output only the heating energy consumption of the PTHP instead of the overall electric consumption?

On Thu, Sep 27, 2012 at 11:36 AM, Griffith, Brent <brent.griffith@xxxxxxxx> wrote:

This was caused by confusion over the meaning of an output variable for the PTHP. ?Packaged Terminal Heat Pump Total Zone Heating Energy? is the heat output, while ?Packaged Terminal Heat Pump Electric Consumption? is the electricity use that could be compared to end use consumption.

From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On Behalf Of Vinay Devanathan
Sent: Thursday, September 27, 2012 9:19 AM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: Re: [EnergyPlus_Support] Discrepancy in reporting

Has anyone else come across this issue?
On Wed, Sep 26, 2012 at 12:08 PM, Vinay Devanathan <vinay.devanathan@xxxxxxxxx> wrote:

Thanks, Linda. I have submitted a ticket with the HTML and IDF.

On Wed, Sep 26, 2012 at 11:56 AM, Linda Lawrie <linda@xxxxxxxxxxxxxx> wrote:

I suggest you send the input file and report to the helpdesk. Who might be able to tell you if this is a bug or not.

We're coming down to the last changes before release -- we won't be monitoring the Yahoo Group much.

At 09:52 AM 9/26/2012, Vinay Devanathan wrote:
Hello All,

I ran a 1 zone simulation recently with just a Packaged terminal Heat Pump object and found some discrepancy in the reporting of the results.

I have attached the HTML report file. The issue is - In the ABUPS report, the Heating EndUse Energy reported is not the same as the total kWh reported in monthly reports for that same PTHP.

Could someone please tell me if it is a bug and I will have to work around that?

Thank you.

Content-Type: text/html; charset=US-ASCII; name="Test_Model-No_ETable.html"
Content-Disposition: attachment; filename="Test_Model-No_ETable.html"
X-Attachment-Id: f_h7km3wqg0

--
Vinay Dev

--
Vinay Dev

--
Vinay Dev

Vinay Dev