Yes, use a single plant loop to serve the VRF condenser.
Here's a file I have been playing with.
The imf file is the building and VRF system.
The idf is the plant loop.
The in.idf file is these two files after EPMacro assembles them together.
On 10/22/2012 12:47 PM, Omar Tabuyo
wrote:
Dear all,
I am trying to simulate a VRF water condenser. I know that you can do it with version 7.2. In proyect, the water temperature is defined between 35ºC and 20ºC, so, I should include a boiler in the condenser loop.
Is this configuration possible today in energyplus? Anyone know how i can simulate it?
Thanks in advance
-- Richard A. Raustad Senior Research Engineer Florida Solar Energy Center University of Central Florida 1679 Clearlake Road Cocoa, FL 32922-5703 Phone: (321) 638-1454 Fax: (321) 638-1439 or 1010 Visit our web site at: http://www.fsec.ucf.edu UCF - From Promise to Prominence: Celebrating 40 Years
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___