Ignore the “error”. It does not prevent the simulation from running and, as you said, indicates a correct and proper condition.
E+ is just letting you know about an unusual condition.
James V Dirkes II, PE, BEMP, LEED AP
www.buildingperformanceteam.com
Energy Analysis, Commissioning & Training Services
1631 Acacia Drive, Grand Rapids, MI 49504 USA
616 450 8653
From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On Behalf Of Miroslav Bratanov
Sent: Wednesday, December 05, 2012 4:46 PM
To: EnergyPlus Support
Subject: [EnergyPlus_Support] AirLoopHVAC has no air flow workaround?
Hello all,
I have a building with some indirectly conditioned spaces and I am
modeling a system (PVAV with reheat) just to satisfy the requirement of
Appendix G that all conditioned spaces should be simulated as both
heated and cooled. I set higher and lower setpoint temperatures for the
heating and cooling respectfully, so the system would never turn on. But
during the simulation I get a
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___