Re: [EnergyPlus_Support] Set the power of a cooling tower

[Javed Iqbal <eee.javed@xxxxxxxxx>]

You could put value in " Fan power at Design Air flow Rate" in condenser equipment object. However, unit conversion is required from HP to Watt.

Also refer Input output reference file to know more on this..

Hope this helps!

On Fri, Dec 21, 2012 at 8:17 PM, andresdagm <andresdagm@xxxxxxxxx> wrote:

 

Good day Group,

I have a cooling tower, there the power is 30HP.
I don't figure out were i can set up this information.

i am using a condenser loop and a cooling tower:single speed

thanks you

Dante

--

Javed Iqbal, LEED AP, CEA

Energy Analyst 

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___