I have one question.How can in associate the zones of design builder with the zones of energy plus?I have created my IDF of design builder model, and deleting all HVAC systems because i wanna use the HVAC templates.In IDF editor i have created the systems but i don't know how associate the same with the zones of design builder model.Thanks again!Téc. Ivan Mezzacapa
Desenhista Projetista de Ar Condicionado / Consultor de Eficiência Energética em Ar Condicionado
LinkedIN: http://www.linkedin.com/in/ivanmezzacapaCelular: (11)9963-9326
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
From: jcrossett@xxxxxxxxxxxxxxx
Date: Fri, 11 Jan 2013 08:50:38 -0800
Subject: Re: [EnergyPlus_Support] Re: Technical Question about Simulation Report - Energy Plus
Most of the time I end up deleting the design builder HVAC systems entirely and then adding HVAC systems using the HVAC templates option in Energy Plus.
Here is a video that shows how you could do the same: http://www.youtube.com/watch?v=Q6Mb4Idxm3U
Jeremiah D. Crossett | Senior Analyst | Phase Change Energy Solutions120 E. Pritchard St. | Asheboro, NC 27203 | Mobile 503-688-8951
On Fri, Jan 11, 2013 at 5:50 AM, <EnergyPlus_Support-owner@xxxxxxxxxxxxxxx> wrote:
I believe I already answered this on the helpdesk and this still isn't the DesignBuilder support forum:
"I believe you need to address your questions to the DesignBuilder support, not EnergyPlus support." However, DB folk do have access to this forum.
__._,_.___