Hmmm. Formatting didn’t work very well the first time
James V Dirkes II, PE, BEMP, LEED AP
www.buildingperformanceteam.com
Energy Analysis, Commissioning & Training Services
1631 Acacia Drive, Grand Rapids, MI 49504 USA
616 450 8653
From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On Behalf Of jvd2pe
Sent: Monday, February 04, 2013 8:41 PM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: [EnergyPlus_Support] DX Coil Warnings (again)
Dear Forum, Every time I model a DX coil system with a high percentage
of outdoor air, I receive a LOT of warnings like those shown below. As
I understand them from discussion with the Help Desk, my part load
capacity curves are causing the coil discharge air to exceed saturation
(100% relative humidity). This can be corrected by what appears to be
a LOT of effort to tweak the curves - and I cannot justify expending
that effort. Have any of you encountered the same problem? Have you
found a simple solution? I can live with the warnings because I don't
think they adversely affect the results, but it is possible that the
GBCI
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___