Re: [EnergyPlus_Support] Surface doesn't match!

[prln@xxxxxxxxxx]

It's worked it!

 

Thanks for your assistance, Anderson!

---

Em 31/08/2013 17:09, Anderson Letti < anderson.a.letti@xxxxxxxxx > escreveu:
 

Have you tried using the comand "matching surfaces" in Open Studio?

It should work, even though it may erase your definitions for construction type.

Anderson

Em 31/08/2013, às 15:53, prln@xxxxxxxxxx escreveu:

 

 

Good afternoon, everyone!

I'm modeling a four-story building in OpenStudio.

In the four levels, the zones do not match, that is, the first floor zones are not equal then the second and forth.

The EnergyPlus is returning 31 "warnings" like this below:

br />    GetSurfaceData ** Warning **: Interzone Surface Areas do not match as expected and might not satisfy conservation of energy:
    ~ ** ~ ~ ** Surface Area = 262.1 in = ZN101_LAJE, Zone = ZN101
    ~ ** ~ ~ ** Surface Area = 411.1 in = ZN201_PISO, Zone = ZN201
   
As zones are not symmetrical, there are walls where a face is in a zone, and on the other side, in two other zones. The same occurs with the ceilings and floors.

Does anyone have any idea how to solve these "warnings"?

Best regards,

Paulo Roberto.

 

 

 

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___