[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] Impose Surface face temperature





Hi,

Is there any method to impose surface face temperature or heat flux on a surface, using EMS or any other trick. There is an EMS actuator for surface convection coefficient so maybe any formula which uses only surface face temp and heat flux to find surface convection coefficient.


I tried one way but it didnt worked, 

I set thermostat at 30 degrees, (as surface face I had was always below 30). I forced surface convection coefficient as heat flux/diff of face temp and 30 degrees.



Thanks

 



__._,_.___

Posted by: gauravciitr@xxxxxxxxx


EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The EnergyPlus web site is found at:
http://www.energyplus.net/

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___