Re: [EnergyPlus_Support] Impose Surface face temperature

["Linda Lawrie linda@xxxxxxxxxxxxxx [EnergyPlus_Support]" <EnergyPlus_Support@xxxxxxxxxxxxxxx>]

You could use Other Side Coefficients in the same way that
is used with Slab Temperatures.

At 07:07 AM 6/8/2016, gauravciitr@xxxxxxxxx [EnergyPlus_Support]
wrote:


> Hi,
>
> Is there any method to impose surface face temperature or heat flux on a
> surface, using EMS or any other trick. There is an EMS actuator for
> surface convection coefficient so maybe any formula which uses only
> surface face temp and heat flux to find surface convection
> coefficient.
>
>
> I tried one way but it didnt worked, 
>
> I set thermostat at 30 degrees, (as surface face I had was always below
> 30). I forced surface convection coefficient as heat flux/diff of face
> temp and 30 degrees.
>
>
>
> Thanks
>
>

__._,_.___

---

Posted by: Linda Lawrie <linda@xxxxxxxxxxxxxx>

---

EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The EnergyPlus web site is found at:
http://www.energyplus.net/

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Visit Your Group

• New Members 9

• Privacy • Unsubscribe • Terms of Use

__,_._,___