[Equest-users] fan coil unit and air cooled condenser

[Kevin Kyte]

I am modeling some fan coil units with an air cooled condensing unit and
provide cooling only.  If I try to select a system type of Fan Coil I am
prompted to input a chw loop to which there is none.  Looking at induction
unit I am also prompted to input a chw loop.  I notice that I can cancel out
of these prompts and leave chw loop empty and still run a simulation but I
am skeptical of this.  Is it better to just use a packaged single zone or
will fan coil or induction unit still work?  Thank you in advance for your
advice.

 

Kevin Kyte, LEED AP

RobsonWoese, Inc.

(T) 716-636-1800

(F) 716-636-1856

http://robsonwoese.com <http://robsonwoese.com/index.php> 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20080521/dc6d1395/attachment.htm>