[Equest-users] How to model a bldg with different roof levels?

[Carol Gardner]

Amandeep,

Use the Specify Exact Site Coordinates option on your first DD Wizard screen
to locate each shell. Changing an exterior wall to an interior wall can be
done in the Detailed Data edit mode by creating a new child component, i.e.
interior wall, which uses the same location & geometry of the exterior wall
you want to replace. After you do that just delete the replaced exterior
wall.

Hope that makes sense,

Carol

On Thu, Mar 11, 2010 at 1:58 PM, Amandeep Singh <
amandeep.singh at energycenter.org> wrote:

>  Hello everyone,
>
>
>
> I was trying to model a bldg with 50% area at 25 feet high and remaining
> area at 10 feet. How can I specify different heights in  the footprint of
> this bldg. in eQUEST?  I tried to draw in DD Wizard. First I drew a
> footprint with 25-foot height, then I tied to create a new shell with
> 10-foot height. I wasn’t able to put two shells together. Also, I didn’t
> know how to change exterior walls to interior.
>
>
>
> Any help would be appreciated .
>
>
>
> Regards,
>
> Aman
>
>
>
> [image: http://www.energycenter.org/uploads/CCSE-email-logo.jpg]
>
> *Amandeep Singh*
> Energy Engineer
>
> 8690 Balboa Ave, Suite 100
> San Diego, CA 92123-1502
> 858.634.4729 phone
> 858.244.1178 fax
> www.energycenter.org web
>
>
>
>
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20100311/84d3325a/attachment-0002.htm>