[Equest-users] HP and HW Loops

[Anthony Hardman]

I'm guessing you have a Primary-Secondary loop design?  That being said, it
might be easiest just to create two separate loops and divvy up your boiler
capacity accordingly.

 

 

Anthony Hardman, PE

LEED AP BD&C

Building Performance Analyst

The Green Engineer, LLP

Sustainable Design Consulting

50 Beharrell St

Concord, MA 01742

O: 978/610-2801

C: 720/840-7862

 

From: equest-users-bounces at lists.onebuilding.org
[mailto:equest-users-bounces at lists.onebuilding.org] On Behalf Of Rob Hudson
Sent: Tuesday, October 26, 2010 8:50 AM
To: equest-users at lists.onebuilding.org
Subject: [Equest-users] HP and HW Loops

 

I have a interesting set of systems attached to the same loop.  there is a
hot water loop with boilers providing some heating to a few Cab heaters and
fin tube.  this loop also provides the heating for a Heat pump loop in the
winter, which also has a cooling tower equiped.  i cannot find a way to make
these loops interact with each other due to one being HW and the other WLHP.
Any bright ideas?

thanks for the help.

-- 
Rob Hudson

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20101026/bf9e3921/attachment-0002.htm>