[Equest-users] Supply T too low

[Bill Lafley]

Hello,

Has anyone gotten the warning below?  Is there a fix for it?

**WARNING**********************************************************************
              PREHEAT/HEATING-CAPACITY in SYSTEM EL2 Sys2 (UVT) (G.N5)
              is too low to provide the requested supply temperature for
              the calculated mixed air temperature using total ZONE loads
              (on LS-A/B) and SYSTEM design parameters, plus outside air
              conditions (on LS-C), and specified capacities & air flows.
              Requested temperature is 120.00 calculated is  72.00
              Check HEATING-CAPACITY, HEAT-SET-T, PRE-HEAT-T, MAX-SUPPLY-T,
              DESIGN-HEAT-T, and ZONE loads for consistency.

Thanks,

Bill

-- 

<http://www.cetonline.org>

Bill Lafley <mailto:blafley at cetonline.org> | Energy Analyst
Center for EcoTechnology | 320 Riverside Drive - 1A | Florence MA  01062
413-586-7350 ext. 222 | 413-695-2730 (cell)
<http://www.cetonline.org>www.cetonline.org
<http://www.cetonline.org/Mailist/VR_Signup.php>