[Equest-users] autosizing HVAC in baseline model

[Evangelia Gklezakou]

Hi,
thank you for your response. Could you please send the screen shot because
it wasn't attached in the previous email. I know that I have to put 0
capacity for both heating and cooling and 1.25 and 1.15 sizing ratio
respectively but the next steps are not clear to me.    Thank you.

Regards,
Eva

On Fri, Oct 19, 2012 at 8:34 AM, Peter Baumstark
<pbaumstark at sbcglobal.net>wrote:

> Eva,
>
> I think what you want is to, in DD mode, put the cooling capacity at 0 and
> the cool sizing ratio at 1.15 (I think that's what Appendix G specifies).
> See the screen shot.
>
> Does that answer your question?
>
>
>
> ------------------------------
> *From:* Evangelia Gklezakou <gklezakou.eva at gmail.com>
> *To:* equest-users at lists.onebuilding.org
> *Sent:* Thu, October 18, 2012 5:02:07 PM
> *Subject:* [Equest-users] autosizing HVAC in baseline model
>
> Dear Sirs,
>
> I model the baseline case of a project and I need to calculate the
> capacity and the other parameters  of the HVAC (system 6). If I am not
> wrong I can do this by autosizing but I am in DD mode and so I do not have
> this option. Do I have to do parametric runs in order to calculate the
> required values? Any information regarding this procedure is going to be
> very useful.
> Thank you for the help.
>
> Regards,
> Eva
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20121019/bced4830/attachment-0002.htm>