[Equest-users] Creating multiple footprints for a single building
Aaron Smith
asmith at mreng.ca
Mon May 5 18:07:31 PDT 2014
Sol,
1. You'll need to create a new shell for each group of similar floors in the Design Development Wizard. The shells can then be positioned such that they are immediately above each other.
2. I think it should work fine with one CAD file.
Aaron
Aaron Smith, P.Eng
M&R Engineering Ltd.
Sent from my BlackBerry 10 smartphone on the TELUS network.
Original Message
From: Joe Huang
Sent: Sunday, May 4, 2014 21:44
To: Sol Rosenbaum
Cc: <equest-users at lists.onebuilding.org>
Subject: Re: [Equest-users] Creating multiple footprints for a single building
Use a FLOOR-MULTIPLIER
Sent from my iPhone
Joe Huang
White Box Technologies
346 Rheem Blvd Suite 108D
Moraga CA 94556
(o) 1(925)388-0265
(c) 1(510)928-2683
yjhuang at whiteboxtechnologies.com
On May 4, 2014, at 12:01 PM, "Sol Rosenbaum" <solrosenbaum at gmail.com> wrote:
> Hi,
>
> I am new to eQuest and am modelling a large office building that has a footprint that gets smaller on the higher floors. I have all of the footprints (17 in total) in a single CAD drawing and have uploaded it to eQuest. I was able to get the initial ground floor outline set up, but now I am not sure how to proceed from here . . .
>
> 1. How can I set one outline to be floors 1-10 and a second outline to be floors 11-20 and so on?
>
> 2. I was provided all of the outlines in one CAD drawing with them sitting side by side. Would it be easier if i had them supplied as separate files? Separate layers?
>
> Thanks,
> Sol
>
>
>
>
>
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
More information about the Equest-users
mailing list