[Equest-users] Creating multiple footprints for a single building
Joe Huang
yjhuang at whiteboxtechnologies.com
Sun May 4 17:44:12 PDT 2014
Use a FLOOR-MULTIPLIER
Sent from my iPhone
Joe Huang
White Box Technologies
346 Rheem Blvd Suite 108D
Moraga CA 94556
(o) 1(925)388-0265
(c) 1(510)928-2683
yjhuang at whiteboxtechnologies.com
On May 4, 2014, at 12:01 PM, "Sol Rosenbaum" <solrosenbaum at gmail.com> wrote:
> Hi,
>
> I am new to eQuest and am modelling a large office building that has a footprint that gets smaller on the higher floors. I have all of the footprints (17 in total) in a single CAD drawing and have uploaded it to eQuest. I was able to get the initial ground floor outline set up, but now I am not sure how to proceed from here . . .
>
> 1. How can I set one outline to be floors 1-10 and a second outline to be floors 11-20 and so on?
>
> 2. I was provided all of the outlines in one CAD drawing with them sitting side by side. Would it be easier if i had them supplied as separate files? Separate layers?
>
> Thanks,
> Sol
>
>
>
>
>
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20140504/37e512a9/attachment-0001.htm>
More information about the Equest-users
mailing list