[Equest-users] External Glazing does not display in eQuest 3.64

[Sam Siassi]

Dear Shilpa,

If you have followed the previous recommendations and still nothing, make
sure that in your shell, the zones that you have drawn are in fact inside
(or right on) the footprint (the shell). If the zone goes out of the shell,
then it will cover the external walls and you will not see them in the 3D
view. You might have to look at coordinate values in the shell drawing menu
and the zone drawing menu to make sure everything is aligned.

Hope this helps.

*Sam Siassi*
*Building Scientist and Analytical Engineering*
*Internat Energy Solutions Canada Inc.*
*Tel: 416-628-4658 ext. 149*
*www.internatenergy.com <http://www.internatenergy.com/>*

On Fri, Jun 12, 2015 at 3:20 AM, Sharad Kumar <sharadcapricious at gmail.com>
wrote:

> Dear Shilpa,
>
> This may occur if your model is quite big or heavy.
> It can be so as the building model is quite heavy so the eQUEST is
> sometime incapable to let you view the glazing.
> Sometimes its eQUEST's limitation.
> So the remedy can be just try to have a right click aloof of the building
> structure and click reset camera.
> If this also does not help then try going to different tabs like internal
> loads or air and water side tabs and return to building shell and repeat
> reset camera.
> Hope this may help.Just go in a hit and trial for views. If this does not
> help then may be there can be other issues.
>
>
> Thanks,
> Sharad.Kumar
> Green Horizon Consulting LLP
> Gurgaon
> India.
>
>
> On Thu, Jun 11, 2015 at 3:51 AM, shilpa surana <surana.shilpa at gmail.com>
> wrote:
>
>> Fellow eQuest users,
>>>
>>> I am drawing external glazing in the wizard mode, however, when I exit
>>> out of the wizard mode, the glazing does not show up. I can see the glazing
>>> in the plan view, however, I cant get them to display in 3D View. I am
>>> using eQuest 3.64. Has anyone faced similar issues?
>>>
>>> Best,
>>> Shilpa Surana
>>>
>>>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20150615/ab5b32f8/attachment.htm>