[BLDG-SIM] HRV unit for a GSHP application in eQUEST
Michael Rosenberg
Michael.Rosenberg at state.or.us
Thu Nov 2 10:53:45 PST 2006
Andrew,
The following is from an email sent out with the announcement of eQuest
V3.6. Hope this helps.
**************************
Water-Loop and Ground Source Heat Pump Enhancements
The ability to model water loop heat pumps , in both ground coupled and
conventional configurations,
has been greatly enhanced in two major ways:
1. Water-source heat pump - the PVVT, PVAVS and PSZ systems can
now be specified to be
water-loop heat pump systems thus allowing all the options of these
SYSTEM TYPEs to be available for
use in modeling water -loop heat pump configurations (including
variable flow, staged heating and
cooling, heat recovery, ERV's, as well as sub-zone conditioning and
return air plenum pathways.
**********************************
Mike
Michael Rosenberg
Oregon Department of Energy
625 Marion St. N.E.
Salem, OR 97301-3742
Phone : (503) 373-7809
Fax: (503) 373-7806
>>> "Andrew Craig" <andrew_c at ieice.com> 11/2/2006 10:36:32 AM >>>
I am modeling a single story building that uses a ground-source, water
to water heat pump to serve radiant heating/cooling slabs. A majority
of the building utilizes natural ventilation although mechanical
ventilation is needed for the restrooms and a laboratory space with a
fume hood. The plans call for a HRV unit to provide this make-up air
to
the spaces and this is where I run into problems. For SYSTEM, TYPE =
HP, in eQUEST, it won't let me model an HRV unit although the graphic
appears in the Air-Side HVAC System window. Any suggestions for
turning
on this feature in a HP system?
Andrew Craig | Mechanical Designer/Energy Analyst
INTERFACE ENGINEERING
708 SW Third Avenue | Suite 400 | Portland, OR 97204
direct: 503.382.2696
office: 503.382.2266
fax: 503.382.2262
email: Andrew_C at ieice.com
web: www.ieice.com
Consultants of Choice to the Built Environment for over 35 years
Kirkland, WA | Portland, OR | Sacramento, CA | Salem, OR |
SanFrancisco,
CA
=====================================================You received this
e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list