[BLDG-SIM] eQuest/baseline basics/roof load

Caleb Rockenbaugh caleb at pcdengineering.com
Tue Feb 27 11:12:47 PST 2007


Hello all…
 
I am modeling (eQuest) a ~7000sf office building—one main level above
grade and a smaller mechanical space above (approximately 25% of main
level floor area). The mechanical space is to be heat-only (but is
understood under appendix-g that this will be modeled as both htg&clg),
is enclosed, and located within the attic space below the roof. All
seems to be well and good until looking at the simulation output where
there is no load contribution from the roof (hipped). Wall/Ceiling
heights have been adjusted with no change under this type of roof.
 
Hoping this proves to be as basic as assumed it is—any suggestions are
welcome.
 
Thanks in advance,
 
caleb
 
CALEB ROCKENBAUGH PE, LEED AP
P C D - E N G I N E E R I N G S E R V I C E S
184 WETTERHORN WAY LONGMONT, CO  80501
303.678.1108 T
303.678.1142 F
HYPERLINK "http://www.pcdengineering.com/"WWW.PCDENGINEERING.COM
 
 
 

-- 
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 268.18.4/702 - Release Date:
2/25/2007 3:16 PM
 


===========================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20070227/2af577e0/attachment.htm>


More information about the Bldg-sim mailing list