Dear
Sir/Madam
I am
simulating the temperature in a zone. The zone has just one outside wall. Other
surfaces are regarded as adiabatic. As I did not get reasonable results, I set
internal loads to zero as well as radiation an illuminance in the weather file.
The external temperature at constant 10 °C produces a temperature of about 15
°C in the room. I wonder why the room temperature is different to the external.
I would
appreciate your reply.
Alexander Beisteiner
__________________________________
alexander.beisteiner@xxxxxxxxxxxxxxxxxx
Forschungs- und Technologietransfer
Pinkafeld GmbH
Steinamangerstrasse 21
7423 Pinkafeld
http://www.fh-pinkafeld.ac.at
Tel.: 0043/3357/45370
Fax: 0043/3357/45370/1010
| Yahoo! Groups Sponsor | |
|
|
To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.