----- Original Message -----
Sent: Monday, November 11, 2002 9:59
AM
Subject: Re: [EnergyPlus_Support]
Heating/Cooling Load
Mike,
do you already know when the next release version
1.0.3 will be available?
By the way, the effects of non-steady loads you
also can get for zone sizing calculations. But I assume this is the same
bug as for design day calculations.
Clemens
--
Dr.-Ing. Clemens Felsmann
Institut für Thermodynamik und TGA der TU
Dresden
Tel.: 0351/463 3 5177
Fax: 0351/463 3 7888
mail:
felsmann@xxxxxxxxxxxxxxxxx
----- Original Message -----
Sent: Friday, November 08, 2002 5:58
PM
Subject: Re: [EnergyPlus_Support]
Heating/Cooling Load
Thanks to Clemens' persistence, a bug has been
found related to the
load convergence criteria during the warmup
period. This is causing
the warmup period to exit too early.
The case described below was
exiting after only three warmup days, which
was too soon for this
heavy construction. This resulted in
unsteady conditions during the
steady-state design day. The bug
has been fixed for the next
release, version 1.0.3.
This bug may
impact the results of short-term simulations with heavy
constructions. For lighter weight buildings and for annual
simulations, the overall impact on results should be very
small.
Mike
To unsubscribe
from this group, send an email
to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx
The primary
EnergyPlus web site is found at:
http://www.energyplus.gov
The
group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Your
use of Yahoo! Groups is subject to the Yahoo! Terms of Service.