I want to apologise because I found another
error in my file.
How could I want the setpoints to work (I
want to maintain a temperature between 20-23) if I choose Single Heating and
Single Heating instead of Dual Setpoint???
I am not using all my brain.I am runnig the file
now to check the heating and cooling loads.
I read in previous e-mail that there is a problem
with load convergence criteria in heating/cooling loads.
I was obtaining high loads in
certain hours in the previous file I send.Could this be because of
that?Maybe with the correction of setpoints the loads decrease.
Best regards
Lourenço
| Yahoo! Groups Sponsor | |
|
|
To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.