[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] Setting temperatures on EnergyPlus


I have just started using EnergyPlus and am still feeling my way around the

I would like to construct a simple conductive and convective heat transfer
model for a single wall (with no ground or moisture effects). I would like
to set the air temperatures on both sides of the wall myself. Can you
please advise me whether it is possible to use EnergyPlus in this type of
arrangement and how I would set the temperatures on the input file?
The Engineering Documentation states the Conduction Transfer Module can be
used to find an inner surface temperature and an outer surface temperature
can be calculated using the  weather file along with various other
parameters (Is my understanding of this correct ?). But the documentation
does not give much information on setting inner and outer temperatures,
though I imagine it is possible to do this.

Also if you can set the inner and outer air temperatures can one set the
inner and outer wall surface temperatures?

Many Thanks

Sope Obadeyi

This email may be confidential, may be legally privileged, and is for the intended recipient only.
Unauthorised access, disclosure, copying, distribution, or reliance on any of it by anyone else is prohibited and may be a criminal offence. 
Please delete if obtained in error and email confirmation to the sender.

------------------------ Yahoo! Groups Sponsor --------------------~--> 
Yahoo! Domains - Claim yours for only $14.70

The primary EnergyPlus web site is found at:

The group web site is:

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo! Groups is subject to: