[EnergyPlus_Support] about "Purchased air" RH setpoint

[Zheng Li <lizhenghdf@xxxxxxxxxxxx>]

Dear all:
 
I am using the "Purchased air" to calculate a living/dining room cooling load in summer design day with and without the outside air ventilation rate, i.e., 7.5liter/per person. I want to compare the difference of the sensible and latent cooling load under these two conditions. I have put the indoor temperature setpoint 24C as a "SCHEDULE" and the "ZONE CONTROL: THERMOSTATIC"into the IDF editor, but how can I make a setpoint for indoor RH, i.e., 50% at the same time? Without the RH setpoint, EP also can calculate the cooling load, is there a default RH setpoint in EP? If yes, where and how can I change it value?
 
I am waitting for the answer.
 
Thanks a lot!
 
LI


---------------------------------
全新 Yahoo! Mail - 100 MB 免費電郵儲存量
mail.yahoo.com.hk

[Non-text portions of this message have been removed]



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/dkFolB/TM
--------------------------------------------------------------------~-> 

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
    EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/