[EnergyPlus_Support] convergence value

[ogocer@xxxxxxxxxxxxxx]

Dear all,
i want to check my information about convergence value in C degree or Watt.
i understand it according to the following explanation, we set some
setpoints in temperature or watt. for example heating setpoint is in c or
shading setpoint is in watt. if i set heating setpoint 21 C degrees and my
convergence tolerence value is 0.4 c degree. Then heating will also start
at 20.6 C degree.
"This value represents the number at which the loads values must agree before
?convergence? is reached. (Units for this field is Watts.)
Field: Temperature Convergence
This value represents the number at which the zone temperatures must agree
(from previous
iteration) before ?convergence? is reached. (Units for this field is delta
C)."
is it correct? or am i wrong?
thanks all
O.Gocer


The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
    EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/