[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] Regarding the zone level cooling and heating setpoint temperature



Vignesh,

According to ASHRAE 90.1 Appendix G - 2004, Table G3.1 Section 1.b.

..."(b) All conditioned spaces in the proposed design shall be simulated
as being both heated and cooled even if no heating or cooling system
is to be installed, and temperature and humidity control setpoints
and schedules shall be the same for proposed and baseline
building designs."


I hope this answers your question.

Thanks,

Jason Kirkpatrick


On Fri, Dec 4, 2009 at 5:54 AM, vignesh kumar <vigneshkumar1986@xxxxxxxxx> wrote:
 

Hi
 
i have a doubt in selecting the zone cooling and heating setpoint temperatures in my building , i have modeled a system with pakaged single zone system in the base case and my proposed case system is two stage evaporative cooler , and im supplying the air at temperature of 82 deg fahrenheit for the proposed case , should i have to model the base case with the same 82 deg fahrenheit as my zone cooling set point temperature or 75 degree fahrenheit pls clarify my doubt
 
Thanks and Regards
Vignesh

--
vigneshkumar



__._,_.___


The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.



Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___