Âthank you dashamir, I'll try it!
dashamir marini å??é??:
>
>
> Hello
>
> From first view of Warning message seems that mass flow rate among out
> and in node at PlantSupplySide exceed tolerance value which you have
> input in your idf file. That means some leakage may have occured in
> demand side (distribution system or zone equipments) of your system.
> Usually this happen for air system flow, and I'm not sure if it can
> happen for water flow too.
> One my suggestion would be: try to increase tolerance value just to
> understand if this warning will occure more of course without
> exceeding limit values. If happen again try to check control objects
> in idf file.
>
> that is my opinion
>
> good luck
>
> Dashamir
>
>
--
ã??Give my best wishes to you!
Respectfully yours, YunPeng Hu
Huazhong University of Science and Technology
Wuhan, Hubei, China
hyp@xxxxxxxxxxxxxxxxx
hyp6789@xxxxxxx
__._,_.___
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___