I am trying to reset the watts on the following steam
generator:
SteamEquipment,
Direct Water, !-
Name
unconditioned, !-
Zone Name
Always
On,
!- Schedule Name
EquipmentLevel,
!- Design Level Calculation Method
50,
!- Design Level {W}
,
!- Watts per Zone Floor Area {W/m2}
,
!- Watts per Person {W/Person}
1,
!- Fraction Latent
,
!- Fraction Radiant
,
!- Fraction Lost
General;
!- End-Use Subcategory
I assumed I could use an actuator:
EnergyManagementSystem:Actuator,
MoistureGain,
!- Name
Direct
Water, !-
Actuated Component Unique Name
SteamEquipment,
!- Actuated Component Type
Design
Level {W}; !- Actuated Component
Control Type
But this causes a system crash, so I must not be doing this
correctly. I also tried to manipulate the schedule and could not get the
right values to avoid crashing. Can someone give me a little guidance?
Ned
Lyon, P.E. (MA)
Staff Consultant
SIMPSON GUMPERTZ & HEGER
| Engineering of Structures and Building Enclosures
41 Seyon Street, Bldg. 1, Suite 500
Waltham, MA 02453
781.907.9000 main
781.907.9350 direct
781.907.9009 fax
www.sgh.com
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___