Wrong Control Type -- try “District
Heating Power Level”
Remember these can be echoed out to the
EDD file for on-the-fly documentation of what actuators are available for a
particular run.
From:
Sent: Friday, July 16, 2010 3:23
PM
To:
Subject: [EnergyPlus_Support]
I am trying to
reset the watts on the following steam generator:
SteamEquipment,
Direct Water,
!- Name
unconditioned, !-
Zone Name
Always
On,
!- Schedule Name
EquipmentLevel, !- Design
Level Calculation Method
50,
!- Design Level {W}
,
!-
,
!-
1,
!- Fraction Latent
,
!- Fraction Radiant
,
!- Fraction Lost
General;
!- End-Use Subcategory
I assumed I could
use an actuator:
EnergyManagementSys
MoistureGain,
!- Name
Direct Water,
!- Actuated Component
Unique Name
SteamEquipment, !-
Actuated Component Type
Design Level {W}; !- Actuated
Component Control Type
But this causes a
system crash, so I must not be doing this correctly. I also tried to
manipulate the schedule and could not get the right values to avoid
crashing. Can someone give me a little guidance?
Ned Lyon, P.E. (MA)
Staff Consultant
SIMPSON GUMPERTZ & HEGER
| Engineering of
Structures and Building Enclosures
781.907.9000 main
781.907.9350 direct
781.907.9009 fax
www.sgh.com
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___