Hi all,
I am trying to incorporate the RH control of interior air into
the model (see attached model). I built the model for single zone and followed
the available recommendations in the documentation and online to setup properly
the RH control of the interior space. I made the model up and running but do
not see effect of incorporated control on RH profile in interior space. Would
appreciate any suggestions or hints to go around this problem.
Thanks.
Danko
Davidovic
Staff II - Building Technology
SIMPSON GUMPERTZ & HEGER
| Engineering of Structures and Building Enclosures
41 Seyon Street, Bldg. 1, Suite 500
Waltham, MA 02453
781.907.9000 main
781.907.9260 direct
781.907.9009 fax
www.sgh.com
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___