The last two fields are correct, from an EMS point of
view. The first two fields would depend on the rest of your input.
From:
EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On
Behalf Of Sotiris Papantoniou
Sent: Wednesday, October 20, 2010 4:37 AM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: [EnergyPlus_Support] ems actuator for ideal loads air system
Hello
list,
I
am trying to set an actuator controlled by “bcvtb” but the whole
system crash. I am aware that I should ask the “bcvtb” help, but I
believe that it is the same problem as setting an ems-actuator. The settings I
am using are:
ExternalInterface:Actuator,
HVAC,
!- Name
Zone1HVAC,
!- Actuated Component Unique Name
Ideal Loads Air System, !- Actuated Component Type
Air Mass Flow Rate; !- Actuated Component Control
Type
If
these values where used in an ems-actuator whould they be right ?
Thank
you
Sotiris
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___