Hello list,
I am trying to set an actuator controlled by “bcvtb”
but the whole system crash. I am aware that I should ask the “bcvtb”
help, but I believe that it is the same problem as setting an ems-actuator. The
settings I am using are:
ExternalInterface:Actuator,
HVAC,
!- Name
Zone1HVAC,
!- Actuated Component Unique Name
Ideal Loads Air System, !- Actuated
Component Type
Air Mass Flow
Rate; !- Actuated Component Control Type
If these values where used in an ems-actuator whould they be
right ?
Thank you
Sotiris
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___