For interzone surfaces (surfaces between two zones that are
marked as such), you can create the surface in one zone and the program
will create the surface in the 2nd zone. But it still needs both of
them.
There is a tip on minimizing time to run a simulation in the Tips &
Tricks document.
By and large, we have found V6 to be MUCH faster than earlier versions
due to some things we have incorporated.
At 09:25 PM 11/13/2010, Vinay Devanathan wrote:
I am trying to run a simulation which is
taking a considerably long time to complete. I have been taking all
efforts to minimize the number of time consuming factors in the
model.
In the course of that effor, I would like to ask a
question.