[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [EnergyPlus_Support] Error message


I have seen many such cases.  One extra semicolon in the wrong place can give you that.

 Dr. Li  


To: EnergyPlus_Support@xxxxxxxxxxxxxxx
From: francisco.minoyetti@xxxxxxxxxxxxxxxxxxxxx
Date: Tue, 22 Feb 2011 13:20:07 +0000
Subject: [EnergyPlus_Support] Error message

Dear Forum,

Can the simulation be terminated due only to warnings?
It's weird actually because at the end of the error message there is no "Error count: Total warnings...total severe...total fatal..."

I just see:

** Warning ** GetSurfaceData:The total number of floors, walls, roofs and internal mass surfaces in Zone 328866
** ~~~ ** is < 6. This may cause an inaccurate zone heat balance calculation.

** Warning ** Calculated design heating load for zone=328866 is zero.
** ~~~ ** Check Sizing:Zone and ZoneControl:Thermostat inputs.

** Warning ** CalcDaylightCoeffMapPoints: For Zone="330780" External Window="W_328687_14_0_0_0_0_0_WIN"in Zone="328687" map point is less than 0.15m (6") from window plane
** ~~~ ** Distance=[0.1 m] map point=[-13.1,-9.7,5.0], Inaccuracy in Map Calcs may result.

Is this normal?
Any advice?




Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:

The group web site is:

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe