Hi,
I am not able to reproduce the similar error that you are getting. Looking at the error in your email it apears that 'Zone Equipment 1 Object Type' in ZoneHVAC:EquipmentList=ZONEEQLIST_01NORTH is not correct but the input objects in the email do seem to be correct. Maybe i am missing something here. If you send the input file to helpdesk one of us will look into it. Do all the objects ZoneHVAC:EquipmentConnections and ZoneHVAC:EquipmentList correctly point to their zone?
Thanks,
Chandan
On 7/15/2011 3:11 PM, jvd2pe wrote:
Dear E+ forum,
I'm missing something, but cannot see it, so I'm hoping one of you can help. Thanks in advance!
This is the error (The same error occurs for each zone and results in termination of the run before completion):
** Severe ** During ZoneHVAC:EquipmentList Input, Invalid Component Type input=
** ~~~ ** Component name=
** ~~~ ** In ZoneHVAC:EquipmentList=ZONEEQLIST_01NORTH
Here are the objects which seem to be part of the problem:
ZoneHVAC:EquipmentList,
ZoneEqlist_01North, !- Name
ZoneHVAC:AirDistributionUnit, !- Zone Equipment 1 Object Type
AirDistUnit_01North, !- Zone Equipment 1 Name
1, !- Zone Equipment 1 Cooling Sequence
1; !- Zone Equipment 1 Heating or No-Load Sequence
ZoneHVAC:AirDistributionUnit,
AirDistUnit_01North, !- Name
NodeIn_Zn_01North, !- Air Distribution Unit Outlet Node Name
AirTerminal:SingleDuct:VAV:Reheat, !- Air Terminal Object Type
VAV_01North; !- Air Terminal Name
AirTerminal:SingleDuct:VAV:Reheat,
VAV_01North, !- Name
SchCpct_AlwaysOn, !- Availability Schedule Name
NodeOut_VVDpr_01North, !- Damper Air Outlet Node Name
NodeOut_ZnSpltr_01North, !- Air Inlet Node Name
Autosize, !- Maximum Air Flow Rate {m3/s}
Constant, !- Zone Minimum Air Flow Input Method
0.3, !- Constant Minimum Air Flow Fraction
, !- Fixed Minimum Air Flow Rate {m3/s}
, !- Minimum Air Flow Fraction Schedule Name
Coil:Heating:Gas, !- Reheat Coil Object Type
RhtCoil_01North, !- Reheat Coil Name
Autosize, !- Maximum Hot Water or Steam Flow Rate {m3/s}
0, !- Minimum Hot Water or Steam Flow Rate {m3/s}
NodeIn_Zn_01North, !- Air Outlet Node Name
0.001, !- Convergence Tolerance
Reverse; !- Damper Heating Action
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___