[EnergyPlus_Support] Chiller Sizing

[Vinay Devanathan <vinay.devanathan@xxxxxxxxx>]

Hello All,

 

I simulated a model initially with two Chillers, which were equally sized (autosized and obtained from the simulation output).

 

I added a third Chiller to reduce the load on each, thinking each Chiller will be sized for a lesser capacity as the load will be split in three instead of two.

 

But, from the output I get, all three Chillers are now sized to the same exact capacity (to what I had when there were two Chillers). Is there anything obvious that I am missing?

 

I even changed the Load Distribution scheme, but to no effect.

 

Any help would be great.

 

Thank you.

 

Vinay

 

 

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___