[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] Re: Can one apply ZoneHVAC:LowTemperatureRadiant:VariableFlow to InternalMass su





Every floor also has a heat gain or loss, but your not modeling every floor. This is taken care of in the zone multiplier. Same should apply for the zone HVAC system. The multipliers handle it.

On 7/27/2011 2:09 PM, Jean marais wrote:
 

Help! I think I need to artificially increase the radiative area of a chilled ceiling. I have a big building where not every floor is modelled, but in reality every floor has a chilled ceiling.

--- In EnergyPlus_Support@xxxxxxxxxxxxxxx, "Jean marais" <jeannieboef@...> wrote:
>
> Can one apply ZoneHVAC:LowTemperatureRadiant:VariableFlow to InternalMass surface?
>
> I think the radiative surface area is too little when modelling 3 stories as one block with one floor area and one ceiling.
>


-- 
Richard A. Raustad
Senior Research Engineer
Florida Solar Energy Center
University of Central Florida
1679 Clearlake Road
Cocoa, FL  32922-5703
Phone:   (321) 638-1454
Fax:     (321) 638-1439 or 1010
Visit our web site at: http://www.fsec.ucf.edu

UCF - From Promise to Prominence: Celebrating 40 Years


__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___