I should know this… but I don’t.
· I have defined a simple boiler plant loop as shown below
· Boiler 1 is defined to operate first, then both Boilers, based on their load capacity
· From the CSV report variables, the boilers appear to be operating as I intend:
o Boiler 1 is operating (indicated by raising the temp of incoming water)
o Boiler 2 is NOT operating (indicated by temp of incoming water remaining unchanged)
· BOTH boiler branches have flow, but I want flow only when the boiler is active
· For the Boiler Branches, I defined:
o the Pumps as “passive” and boilers as “active” for both bra
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___