[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] OA controller and Heat Recovery



Hi, 

I am modeling heat recovery device for a VAV system. Based on the E+ documentation, input to the minimum OA air tab on OA controller has to be manually given(instead of auto-sizing) if the heat recovery device is modeled. I gave the minimum OA value and the file results in the below shown error. If I make the minimum OA input as zero then there are no errors. However, with 0 input in the minimum outdoor air tab the heat recovery device doesn't not recover any heat. 

Does any of you know how to use heat recovery device in E+?

Thanks,
Harshana

** Severe  ** FindRootSimpleController: Controller error for controller = "VAV SYSTEM 4 COOLING COIL CONTROLLER"
   **   ~~~   **  Environment=Burke Lakefront OH USA TMY3 WMO#=725245, at Simulation time=10/01 07:00 - 08:00
   **   ~~~   **   Controller function is inconsistent with user specified controller action = Reverse action
   **   ~~~   **   Actuator will be set to maximum action
   **   ~~~   ** Controller control type=Temperature
   **   ~~~   ** Controller temperature set point = 11.60 [C]
   **   ~~~   ** Controller sensed temperature = 32.76 [C]
   **   ~~~   ** Controller actuator mass flow rate set to 17.65 [kg/s]
   **   ~~~   ** Controller actuator temperature = 6.74 [C]
   **   ~~~   **   Note: Chilled water coils should be reverse action and the entering chilled
   **   ~~~   **         water temperature (controller actuator temperature) should be below the setpoint temperature
   **   ~~~   **   Note: Hot water coils should be normal action and the entering hot
   **   ~~~   **         water temperature (controller actuator temperature) should be above the setpoint temperature



------------------------------------

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/EnergyPlus_Support/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/EnergyPlus_Support/join
    (Yahoo! ID required)

<*> To change settings via email:
    EnergyPlus_Support-digest@xxxxxxxxxxxxxxx 
    EnergyPlus_Support-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/