THe value 1 to 2 or 2 to 1 is the flow rate. You have to inside or to outside.
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
From: ahneto@xxxxxx
Date: Fri, 29 Jun 2012 13:54:19 -0300
Subject: [EnergyPlus_Support] Actual Air flow ?
Dear Forum,
I modeling a room with the AirFlowNetwork object. I would like to
confirm the following:
When I set as output variable AirflowNetwork Mass Flow Rate from Node
1 to 2 and AirflowNetwork Mass Flow Rate from Node 2 to 1 for a
exterior window, the difference between these two variables will give
the actual flow rate and the direction will be set verifiying which
variable is greater?
Regards,
Alberto Hernandez Neto
I modeling a room with the AirFlowNetwork object. I would like to
confirm the following:
When I set as output variable AirflowNetwork Mass Flow Rate from Node
1 to 2 and AirflowNetwork Mass Flow Rate from Node 2 to 1 for a
exterior window, the difference between these two variables will give
the actual flow rate and the direction will be set verifiying which
variable is greater?
Regards,
Alberto Hernandez Neto
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___