[EnergyPlus_Support] Regarding the problem of Cooling Coil sizing

[sheelam khare <sheelam_khare_26@xxxxxxxxxxx>]

Hello All,

I am trying to simulate a building located at Barcelona, Spain for LEED NC certification. During simulation I am facing the problem of cooling coil sizing. After running the simulation, the following waring is appears many time with respect to all the zones-


** Warning ** SizeDXCoil: Coil:Cooling:DX:SingleSpeed BLOQUE1:A3%SECRETARIA PTAC COOLING COIL
   **   ~~~   ** ...Rated Total Cooling Capacity will be limited by the minimum rated volume flow per rated total capacity ratio.
   **   ~~~   ** ...DX coil volume flow rate (m3/s) = 7.229479E-002
   **   ~~~   ** ...Requested capacity (W) = 2192.909
   **   ~~~   ** ...Requested flow/capacity ratio (m3/s/W) = 3.296E-005
   **   ~~~   ** ...Minimum flow/capacity ratio (m3/s/W) = 4.027E-005
   **   ~~~   ** ...Adjusted capacity (W) = 1795.252

I tried to solve this but did not find the right solution.
Please give your suggestions, your suggestions are very helpful for me.

Thanks with regards..
Sheelam Khare..

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___