[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] Sizing warning message on temperature difference





Hi,

I'm getting this warning message after a run:

   ** Warning ** SizeZoneEquipment: Supply air temperature (calculated) within 5C of zone setpoint temperature
   **   ~~~   ** ...check zone thermostat set point and design supply air temperatures
   **   ~~~   ** ...zone = "ZONE 1F ENTRANCE WEST" first occurrence during cooling load calculations
   **   ~~~   ** ...predicted zone cooling load = -863.19 W
   **   ~~~   ** ...zone temperature            = 20.00 C
   **   ~~~   ** ...supply air temperature      = 16.00 C
   **   ~~~   ** ...temperature difference      = -4.00000 C
   **   ~~~   ** ...calculated mass flow rate   = 0.21163 kg/s

I understand the general purpose of the temperature difference check: avoid high flow rates.
What I don't understand is why the "zone temperature" is reported as being 20 degC, when my thermostat cooling setpoint is 24 degC.

Am I wrong in assuming that "zone temp" should be the cooling setpoint? If so, why recommend to check the zone thermostat in the warning message?

I'm confused!

Thanks in advanced for your help,
Patrick Bivona



__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___