[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] Increase timestep EnergyPlus



Not without a major restructuring of the simulation engine. You're probably better off keeping energy plus at 1 minute and just simulating multiple sub minute time steps in Maltab.

On Nov 27, 2013 10:15 AM, "Charlotte Goovaerts" <chgoovae@xxxxxxxxx> wrote:
 


Dear EnergyPlus usersx
I was wondering if it is possible to increase the timestep in EnergyPlus to 120 (or even 360) times per hour instead of 60 times per hour? I would need this to establish a connection between EnergyPlus and Matlab Simulink. I tried to change the maximum value of the timestep by setting it to 360 in the idd file. The result was that EnergyPlus calculated the system 4 times per hour, instead of every 30 seconds or every 10 seconds. Could someone please tell me if it is possible to implement a shorter timestep and how it could be done? Thank you in advance.
Charlotte Goovaerts



__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.



Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___