[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] two sets of connectorLists in a single loop

You can use HeaderedPumps:ConstantSpeed or HeaderedPumps:VariableSpeed, 
which are single components and hence don't need a splitter and a mixer.


On 12/15/2013 4:35 PM, adrianchong85@xxxxxxxxx wrote:
> Dear EnergyPlus Users,
> I am trying to model the following plant loop in EnergyPlus
> 2 chillers in parallel connected to 2 pumps in parallel
> ----- -- chiller1-- ----- --pump1-- ---------
>        \ chiller2 /       \ pump2 /
> Howerver EnergyPlus only allows the use of a single set of splitter 
> and mixer in each loop (do correct me if I'm wrong).
> Hence I would like to seek advice on some of the methods/best 
> practices that has been taken to work around this (alternative to 
> modeling 2 pumps in parallel).
> Thank you and I would greatly appreciate any inputs
> Regards,
> Adrian

Philip Haves
Leader, Simulation Research Group
Lawrence Berkeley National Laboratory
One Cyclotron Road, MS 90R3145
Berkeley, CA 94720-8134
(510) 486 6512 (office)
(510) 486 4089 (fax)


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:

The group web site is:

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Yahoo Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID required)

<*> To change settings via email:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo Groups is subject to: