ÂI think I have seen this when the kW value is less than 0.5. I think some rounding occurs in the report creation. Does that apply for your system?
Â
James V Dirkes II, PE, BEMP, LEED AP
www.buildingperformanceteam.com
Energy Analysis, Commissioning & Training Services
1631 Acacia Drive, Grand Rapids, MI 49504 USA
616 450 8653Â
From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx]
Sent: Thursday, July 03, 2014 1:01 PM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: [EnergyPlus_Support] Summary reports problem - Demand end-use is 0 W, while energy end-use is not 0kWhÂ
Â
Dear group,Â
Has anyone encountered this problem before? The summary report shows 0 W  in the Demand End Use Components Summary table, while still having energy reported for that end-use not 0?
Â
This happened in different projects and for different end-use categories, eg. this case  Exterior lighting, or on another project cooling and heating.
Any thoughts on what might be the problem?
Â
Regards,
Santiago
__._,_.___