On 11.11.2014, at 21:49, "lmblanes@xxxxxxxxx [EnergyPlus_Support]" <EnergyPlus_Support@xxxxxxxxxxxxxxx> wrote:
Dear Modellers
I have a repeating problem in my model. It is the typical "temperature out of bounds".
I dont use "finite differences".
I use Full Exterior
The zones are not conditioned and the loads are not very high
The "surface temperature upper limit" is set to 2000
Any idea about what can be wrong? It strikes me that the the temperature is negative
Thanks
Luis
------------------------------------------------------------------------------------------------
Severe ** Temperature (low) out of bounds [-192.18] for zone="LEVEL6.50CONCOURSE:IDEALLOADS3", for surface="LEVEL6.50CONCOURSE:IDEALLOADS3_PARTITION_10_0_10104"
** ~~~ ** During Warmup & Sizing, Environment=SUMMER DESIGN DAY IN FIUMICINO TERMINAL 1 JUL, at Simulation time=07/15 00:00 - 00:00
** ~~~ ** Zone="LEVEL6.50CONCOURSE:IDEALLOADS3", Diagnostic Details:
** ~~~ ** ...Internal Heat Gain [15.000] W/m2
** ~~~ ** ...Infiltration/Ventilation [0.000] m3/s
** ~~~ ** ...Mixing/Cross Mixing [0.000] m3/s
** ~~~ ** ...Zone is not part of HVAC controlled system.
__._,_.___
Posted by: "jeannieboef@xxxxxxxxx" <jeannieboef@xxxxxxxxx>
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
__,_._,___