Re: [EnergyPlus_Support] VAV damper position

["Jean Marais jeannieboef@xxxxxxxxx [EnergyPlus_Support]" <EnergyPlus_Support@xxxxxxxxxxxxxxx>]

The last time I did that was 3 years ago for CO2 demand control. I defined the damper to work with a fraction open schedule and used the EMS to overwrite schedule values during simulation.

On 8 Oct 2015 7:09 pm, "Fakeha Sehar fakeha_s@xxxxxxxxx [EnergyPlus_Support]" <EnergyPlus_Support@xxxxxxxxxxxxxxx> wrote:

 

I want to fully close the dampers in the VAV boxes so that no cold air is supplied to the zones using EMS. What actuator can be used in order to achieve this. Should the Zone VAV BOX DAMPER NODE,System Node Setpoint,Mass Flow Rate Setpoint, actuator be used and set to zero s that no cold air enters the zone.

__._,_.___

---

Posted by: Jean Marais <jeannieboef@xxxxxxxxx>

---

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Visit Your Group

• New Members 10

• Privacy • Unsubscribe • Terms of Use

__,_._,___