[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] Fixing system sizing values





Hi, everyoneï¼?


I recently working on simulations with setpoints change and ventilation rate change. I want to fix the system sizing as the same with the base case instead of letting it autosized by the Energy Plus. I tried to find sizing values in the summary report of the base case, but there are some values I couldn't find, including:

VAV Design Outdoor Air Flow Rate (m3/s)

VAV Box Maximum Air Flow Rate (m3/s)

Reheat Coil Maximum Hot Water or Steam Flow Rate (m3/s)

DX Two Spped Cooling Coil High Speed Gross Rated Total Cooling Capacity (W)

DX Two Spped Cooling Coil Low Speed Gross Rated Total Cooling Capacity (W)

Do I need to fix all these values to represent the case that with no change in hardware but only changing of setpoitns and ventilation rate? If so, where can I find those values for base case? Thanks a lot!


Best Regards,

Kelly




__._,_.___

Posted by: hkllzhang@xxxxxxxxx


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___